06-19-2020, 06:41 PM
Here's the big clue.....
When the tanks get near full the vent stack is covered and the tank kinda "burps" a little when you flush. Once you tune in on that ,,you'll always know when to dump !
The sensors always crud up or just rust , On my first rig with tanks I actually drilled new holes and installed new sensors (basically just bolts attachet to wires that short out at the water hits them.. I think the bottom one was the ground and the others attached to the indicator lights plus a bit of electronics to increase the weak short voltage...
Anyhoo , there are now sensors that just stick to the outside of the tanks and never crud up !
I'm passing on either for this rig ,,,the burps never fail and are included free of charge with every tank...
When the tanks get near full the vent stack is covered and the tank kinda "burps" a little when you flush. Once you tune in on that ,,you'll always know when to dump !
The sensors always crud up or just rust , On my first rig with tanks I actually drilled new holes and installed new sensors (basically just bolts attachet to wires that short out at the water hits them.. I think the bottom one was the ground and the others attached to the indicator lights plus a bit of electronics to increase the weak short voltage...
Anyhoo , there are now sensors that just stick to the outside of the tanks and never crud up !
I'm passing on either for this rig ,,,the burps never fail and are included free of charge with every tank...
stay tuned
![[-]](https://vandwellerforum.com/images/collapse.png)