Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
So it begins...... Battery spot welder
I strapped the enclosure housing my DMEGC 10s2p to my  board to my deck between my feet, both at 42v, parallel them through my new 14 awg XT90 to 5.5x2.5mm adapter, and went for a few mile test run.

All went well.

Decided to top up both batteries and lqter go for the longest post dinner cruise yet.

Found the dmegc was not charging and had to remove enclosure and reseat the fuse.

When i was returning  the encloaure gasket, there was a giant spark, a pop and a flash

.    

The 5.5 x 2.5 mm barrel plug found a conductive inside corner to complete the circuit.

So we went for a short evening cruise instead
Reply


Messages In This Thread
RE: So it begins...... Battery spot welder - by sternwake - 10-16-2025, 04:38 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)