Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New Project- Code name "Journey"
Wow-- Really?

That is a really clever use for them.. LOLOLOLOLOLOLOL *gasp for air*

and Thanks Smile
My body is a temple- Ancient and crumbling,  
probably cursed 


Dog Bender with 4.2 Stinkin' Badges 
[-] The following 1 user says Thank You to GypsyDogs for this post:
  • Cammalu (06-16-2019)
Reply
I made a 'To Do' list for the trailer.
6 of 7 Big (time and/or labor intensive) things are crossed off!

One more Big thing, then 8 Little things and the necessary-things-list is complete. Whew/Yay
My body is a temple- Ancient and crumbling,  
probably cursed 


Dog Bender with 4.2 Stinkin' Badges 
Reply
Yay!


Sent from my iPhone using Tapatalk
monkeyfoot
[-] The following 1 user says Thank You to Cammalu for this post:
  • GypsyDogs (06-16-2019)
Reply
Major progress is a good thing. Yippee, time for a celebration.
Brian

2000 Roadtrek 200 Versatile "The Beast" (it has been tamed hopefully)  I feed it and it doesn't bite me.   Angel
[-] The following 1 user says Thank You to B and C for this post:
  • GypsyDogs (06-16-2019)
Reply
lol- I need a list for my list..
trying to do SO many things at the same time.
Water Heater install today (house, not trailer), paperwork/signatures begins this week.., final round/s of packing and jettisoning...while still working my day-job.

My hit list this week for the trailer is Short.. Only things that will require a ladder (before it gets packed into the moving truck)
I will do the rest, after the tornado is over.. lol
My body is a temple- Ancient and crumbling,  
probably cursed 


Dog Bender with 4.2 Stinkin' Badges 
[-] The following 1 user says Thank You to GypsyDogs for this post:
  • rvpopeye (06-19-2019)
Reply
lower wiring secured, battery grounded to frame and secured
    , rear bed support (was in the way of battery/wiring work..) re-attached, and clever mid-frame bed support idea/parts acquired, 
tv de-flapped and impact-padded.
   
with proper supervision, of course..
   


next up-
mid-frame bed support.
the 12v power ports. (x3)
finishing the 'shoulder' insulation in the curve where the wall meets the ceiling.
framing the window.
tiny over-bed shelf (with power port on underside..)
adding reflective strip here and there..
securing upper wiring.
and that is it for essentials.......  ooooo, aaaaahhh
My body is a temple- Ancient and crumbling,  
probably cursed 


Dog Bender with 4.2 Stinkin' Badges 
[-] The following 1 user says Thank You to GypsyDogs for this post:
  • heron (07-27-2019)
Reply
Bed support done, a couple power ports (one on the little over-bed shelf..), tie points for awning poles (under side of bed platform), and the solar wiring covered nicely- but so that I can access, if needed.
My body is a temple- Ancient and crumbling,  
probably cursed 


Dog Bender with 4.2 Stinkin' Badges 
[-] The following 1 user says Thank You to GypsyDogs for this post:
  • rvpopeye (07-05-2019)
Reply
Rear upper wall insulated, floor vent screened, side door screen tailored (excess saved for floor vent..), longer/better wiring found for fridge (now to replace wiring I just installed with better and move power port), shin/dog fender safety installed, window brow installed, ceiling light mounts....
Whew
My body is a temple- Ancient and crumbling,  
probably cursed 


Dog Bender with 4.2 Stinkin' Badges 
Reply
ran out of time yesterday... prerequisite pics

floor vent screen  oooo aaaaahhh
   

and, ya gotta admit, that is a sexy butt-connection  Cool
   

longer wire attached, gee ya think 12/2 low-voltage outdoor landscaping wiring is too much for the dometic fridge?? lol
mounted it down, about a foot off the floor, out of the way, but accessible.  semi-invisible to the common eye...

then remounted the one I had installed, over to the kitchen/desk area.. for aux power.
pics soon-
...wait till you see my USP port bay..
My body is a temple- Ancient and crumbling,  
probably cursed 


Dog Bender with 4.2 Stinkin' Badges 
Reply
"usp"? yeah.. my hands are on strike..
But things are getting done. Move-prepwise- I have scrubbed an epic expanse of cabinetry (huge kitchen, and even bigger storage/pantry/laundry room), cleaned blinds, washed windows/sills/sashes, floors, ceiling... ow

Anyway- this coming week will be trailer-centric. That and getting tranny cooler installed on the blazer...
Found a clever way to mount my USB power ports..

I am planning on filming a 'tour video' end of this coming week..
My body is a temple- Ancient and crumbling,  
probably cursed 


Dog Bender with 4.2 Stinkin' Badges 
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)